Dual cure

Dual-Cure Cationic Epoxies

Use these grades when parts need a short placement window after UV exposure and a room-temperature or low-heat finish cure.

Product categoriesDual-Cure Cationic Epoxies

When to choose this category

These products are for optics, connectors, fibers, and small assemblies that need controlled placement before final cure. They give operators 45 to 60 seconds of open time after pre-activation.

45 to 60 seconds of open time after pre-activation for part placement

Good fit for optics, connectors, prisms, and electronic components

Lower-shrinkage, lower-outgassing systems for more delicate assemblies

Individual product page

UV-2910DC

Lower-viscosity dual-cure UV epoxy for fixturing and assembly

UV-2910DC provides about one minute of post-exposure placement time for optics, connectors, and small electronic parts.

Cationic Epoxy (Dual Cure)2,500 to 5,000 cps-55°C to 150°C

View UV-2910DC page Request info for UV-2910DC

Individual product page

UV-5608DC

Dual-cure UV epoxy with controlled open time for assembly

UV-5608DC provides a dual-cure placement window with more body than UV-2910DC for connectors, lenses, and controlled-flow assemblies.

Cationic Epoxy (Dual Cure)4,000 to 7,000 cps-55°C to 150°C

View UV-5608DC page Request info for UV-5608DC

Compare product categories

Keep narrowing the right FLASHBOND fit.

Compare adjacent cure paths, flow profiles, and product data before moving into a specific grade recommendation.

View all categories Open product table →